Fitting rear bumper trim…

OK, I have a problem. I can’t stop working on this thing. Finished dinner and thought I’d do “one more thing”….

Fitted the GP bumper trim, then ground it out to fit the Mini Fini hitch.
Click the image to open in full size.
Click the image to open in full size.
Click the image to open in full size.
The whole thing looks pretty good, I think. Just lucky, the hitch tubes are perfectly aligned with the end of the cutouts. From the angle most people will see, it looks perfect. Only if you get down on the ground and scrutinize it will you notice it’s not.

It was actually easier than I expected. Already had the grilles cut right, so after I installed the inserts, I just used the die grinder to grind them out to match the holes in the grilles. I’ll pull them out tomorrow and clean them up a bit, then repaint and reinstall. Done.